Applying a decal to a car is an easy and affordable way to add a personal touch to your vehicle. Decals come in a variety of sizes, shapes, and designs, and can be applied to various parts of your car, such as the bumper, hood, windows, and even the brake light. In this blog, we will guide you through the steps of applying a decal to your car's surface.

Step 1: Prepare the Surface

The first step in applying a decal to your car is to prepare the surface. This involves cleaning the area where you will be applying the decal to remove any dirt, grime, or grease that may be present. You can use soap and water or a cleaning solution designed for car surfaces. Make sure to dry the area completely before proceeding.

Step 2: Align the Decal

Next, align the decal to the desired location on your car's surface. This step may take some trial and error to get the placement just right. Once you have the decal in the correct position, use painter's tape to hold it in place temporarily.

Step 3: Remove the Backing

Once you have the decal in the correct position, carefully peel off the backing paper from the decal. Take care not to touch the adhesive side of the decal, as this can cause the decal to lose its stickiness.

Step 4: Apply the Decal

Once the backing paper has been removed, slowly and carefully apply the decal to the surface of your car. Use a squeegee or credit card to smooth out any air bubbles that may be present. Work from the center of the decal outwards to avoid wrinkles or creases.

Step 5: Remove the Application Tape

Once the decal has been applied, carefully remove the application tape by peeling it off slowly at a 45-degree angle. Take care not to pull the decal off with the application tape. If the decal starts to come off, stop peeling and press it back down onto the surface.

Step 6: Allow the Decal to Set

After the decal has been applied and the application tape removed, allow the decal to set for at least 24 hours. This will allow the adhesive to fully bond with the surface of your car.

Tips for Applying Decals to Your Car

  • Work in a clean and dry area to avoid any dust or debris from getting on the decal.

  • Avoid applying decals in extreme temperatures. The ideal temperature range for applying decals is between 50°F and 90°F.

  • Take your time when aligning the decal to ensure it is in the correct position before removing the backing paper.

  • Use a squeegee or credit card to smooth out any air bubbles that may be present.

  • If the decal is large, ask a friend to help you apply it to avoid any wrinkles or creases.

  • If the decal is not sticking properly, use a hair dryer on low heat to warm up the adhesive and press the decal down again.

  • Avoid washing your car for at least 24 hours after applying the decal to allow the adhesive to fully bond with the surface.

In conclusion, applying a decal to your car is a simple and fun way to add a personal touch to your vehicle. By following these easy steps and tips, you can ensure that your decal will be applied correctly and look great for years to come.

Your cart

×